If water is seeping out from beneath the toilet bowl or there is a faint smell of sewer gas in the bathroom, it is definitely time to replace the toilet bowl wax ring.


Step 1: Remove the tank lid and place it in a safe spot. Lay a few towels on the floor to set the toilet on once it has been removed. The towels will cushion the stool and absorb residual water from the tank or bowl.


Step 2: Turn off the water supply to the toilet and flush the stool holding the trip lever down to drain as much water as possible. Use a plunger to remove the excess water held in the trap. Once the water has been drained, disconnect the supply line from the toilet tank.


Step 3: Remove the bolt caps on either side of the toilet base. Use an adjustable wrench to loosen the nuts holding the stool in place. If the nuts are too corroded to remove, use a hacksaw to cut the bolts off below the nuts.

Step 4: Lift the toilet up and off the flange bolts and carefully set it upside down on the towels you laid out earlier.


Step 5: Use a putty knife to scrape the remains of the old wax ring from both the toilet flange and the base of the stool. Clean the area thoroughly to make sure that the new ring will stick properly to both the toilet and the flange.


Step 6: Press the new wax ring over the outlet on the base of the stool. If the ring has a black plastic flange, it should be pointing out away from the stool.


Step 7: Install new toilet bolts onto the floor flange using plastic retaining washers to hold them in place.


Step 8: Preferably with the help of someone to guide you, lift the toilet up and carefully set it back into place. It is very important that the stool is aligned properly with the floor flange before setting the stool into place.


Step 9: Use your body weight to compress the wax ring into place, slightly twisting the stool to assure a proper seal.


Step 10: Secure the toilet into place by hand tightening the nuts onto the flange bolts. Be careful not to over tighten them as the porcelain will crack under pressure.


Step 11: Reattach the water supply line to the toilet tank. Make necessary adjustments to the flushing mechanisms in the tank.

Turn the water supply on and flush the toilet to assure everything is working properly.
Replace the tank lid, pick up your tools and put the toilet seat down before washing your hands of yet another successful household repair.


There are many different types and sizes of wax toilet rings. For best results choose a #3 urethane reinforced wax ring with the black plastic flange.

Email us at info@you-can-fix-it.com to request new fix-it ideas. We also encourage you to add comments or suggestions below each article.

You-Can-Fix-It.com

tools

This article has 1 comment

  1. Have you ever considered about including a little bit more than just your
    articles? I mean, what you say is fundamental and everything.
    Nevertheless think about if you added some great pictures or video clips to give your posts
    more, “pop”! Your content is excellent but with images and video clips,
    this site could certainly be one of the very best
    in its niche. Very good blog!

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *